Skip to content

Specify Forums

Personal tools
You are here: Home » Discuss Specify! » Specify Forum » re-using same search resutls in error message
 

 • re-using same search resutls in error message

Document Actions
Replies: 1   Views: 3467
Up one level
You need to be a registered member to post to this forum.
Prev topic | Next topic

 • re-using same search resutls in error message

Posted by jRosales at 2006-06-19 04:06 PM
Sometimes, after exporting data, I will re-do the search with new parameters, usually catalog numbers. When I go to export this new set of data I receive this error message "Access violation at address C033Fc45. Read of address C033FC45". I have to save and close the search, then re-open it, otherwise the data does not export. Is this fixable?
Member
Posts: 3

 • Re: re-using same search resutls in error message

Posted by cj at 2006-06-20 10:23 AM

This is one of the known bugs in Specify 5.0 and most likely 5.1. It should be fixed by Specify 5.2 (end of summer hopefully). I have tested this a bit and found that after the access violation, I can usually export again successfully. I will see if it would be possible to fix this for Specify 5.1, but we are in the testing phase right now and I am not sure we can fix it at this point.

_________________________
CJ Grady
Specify
(785) 864-7792
Manager
Posts: 38

 
Powered by Plone

This site conforms to the following standards: